...
This sensor can not be configured.
Deploying sensors in Rhye
Provide the rooms template and floor plans to the customer.
A clear indication of the area where the sensors must/will be installed and additional column for the sensors IDs should be available on the sheet.
As described in the installation guide, note 8 last digits of the sensor number in “Sensor ID #” column.
Concerning the TAB sensor, be aware that there are 2 numbers on a sensor, the ID that starts with 58-A0-CB-00 is the one that we need during the configuration.
The Sensor ID is in HEX, so only 0-9; A-F characters are used. All letters are in CAPS.
After completing and receiving the template back it is advised to perform the quality assurance on the sensor IDs to localize the errors.
If all errors are removed, apply the sensor mapping in Rhye > Sensor Devices.
You can manually add a record via 
Or you can also download the Rhye template for quick import.
Caution: When you choose your location, you will see that there are 2 options for the same location. Underneath the location, you see a location ID, it is important that you choose the location with the right location ID from MCS.
