...

This guide focuses on the configuration of the Pointgrab devices on the Pointgrab cognipoint management system (cpms) and Rhye.
This guide assumes a configured asset tree in cpms with floorplan.

...

1. Fill in the following csv file, and keep the format (number of enters between blocks, indenting, etc.)
   

   View file
   name vdab test.csv height 150

   
   
2. Select the correct floor in the asset tree
3. Click the import button
4. Browse for the file and click ok.

Defining areas CPMS

Define the areas where the sensors will measure headcounts

1. Click the Add Area button. The Add Area dialog is displayed.
   Image Added
2. In the Area Name field, enter an informative name for the area.
3. In the Update Frequency field, enter the frequency in seconds at which the sensor will send notifications.
4. For optimal performance, in the Type field, select the type of the area you want to add. 
   Image Added
5. In the Center X field, enter the X coordinate in meters of the area’s center.
6. In the Center Y field, enter the Y coordinate in meters of the area’s center.
7. In the Area Width field, enter the area’s horizontal dimension in meters.
8. In the Area Length field, enter the area’s vertical dimension in meters.
9. Optionally, click in the Select Devices field, then select the checkboxes of the devices whose detection areas you want to cover the new area. This can be useful, for example, if you have some knowledge about occlusions in the sensors’ views, and you want to choose the optimal sensor/s for covering your new area.
   Image Added
10. Click Save. The area is added and displayed both in the Search pane and as a blue rectangle (assuming it’s a valid area) in the floor plan.

Finetuning CPMS

Finetune the location of the area and the sensor device by comparing the live view and the on site situation

Deploying sensors Rhye

1. Go to bohemian
2. Check the Auto-create organization devices box
3. Add a new line
4. Select the pointgrab source
5. Select the detection area from the device id drop down list
6. Give a meaningful name
7. Select pointgrab as the model
8. select the correct organisation
9. click save
10. Change the location id in the tenant's sensor devices