Content Comparison

...

Table of content
TrackNet (tabs)
Hub - Gateway
Motion sensor - PIR
Healthy home - Comfort
Door & Window switch

Anchor
_Toc534723620 _Toc534723620

TrackNet (tabs)

Anchor
_Toc534723621 _Toc534723621

Hub – Gateway

Configuring the Hub will let you set up the Hub as a router, WIFI client, WIFI extender, or WIFI off. It will also let you choose between DHCP and Static IP for ethernet based connections.
Step 1. Check the firmware version
Step 1.1 Go to the trackio grafana platform
Step 1.2 Open router mamagement
Step 1.3 Locate the hub
Step 1.4 Check if the current firmware version is 1.25.02 or later
Step 2. Factory reset the hub with internet unplugged.
Caution! If the hub is connected to the internet it will reconfigure to the standard MCS configuration
Step 3. Join the hubs initial open Wi-Fi network (Tabs-xxxxxxx)
Step 4. Open the configuration html
Step 5. Follow the configuration steps of the configuration tool.

Anchor
_Toc534723622 _Toc534723622

Motion sensor – PIR

There are 5 different parameters that effect the behaviour of a TrackNet motion sensor. Sensitivity, Blind time, pulse counter, window time, and filter type.
Each of these parameters can be altered by sending a downlink to the sensor from the trackio platform.
For calculating the downlink code use the latest version of the downlink encryption sheet.
For configuring multiple sensors at once use the latest version of the downlink configuration program.

Anchor
_Toc534723623 _Toc534723623

Healthy home – Comfort

This sensor can not be configured.

Anchor
_Toc534723624 _Toc534723624

Door & Window switch

This sensor can not be configured.