| Table of Contents |
|---|
Preparation
Make sure you have enough space (3.5mm) between the door and the door frame to install the sensor.
Sensative strips connect over the LoRa network (visit 2.1 Hardware to check compatibility between these sensors and our gateways/hubs). Make sure you install your LoRa hub before installing the sensors (check out LoRa Gateways / Hubs installation guides for more information).
Sensor activation
Per strip, 2 magnets are delivered: 1 for activation (round; compare to the plastic strip on tabs sensors), 1 for operational actions (rectangle). In other words, strips comes in "transport mode": when both of the magnets are attached, the device is idle.
...
| Widget Connector | ||
|---|---|---|
|
Quality Assurance
Once the Sensative Strips are installed and mapped in Cobundu, it's important to do Quality Assurance.
In both GO and StudioLive Floorplans, you should see pulse count adding up each time the door is opened (for ; in Studio > Devices you should see values 0+1+0+1 coming in.
For Live Floorplan and Dashboards, only transition from 0 to 1 is counted = only door opening is counted).
.
What you should see on GO Live Floorplan > View Pulse Count and/or in Studio > Devices:
Remember that in Studio, you might/should also see values from the sensor heartbeat coming in. Don't mistake these for actual data (heartbeat = sending 1+1+1 as values; whereas real data would be 0+1+0+1...)
