* No longer available
| Table of Contents |
|---|
...
Datasheets can be found here: Data sheet Tabs (Tracknet) hubs & sensors /wiki/spaces/SUM/pages/492584
Ethernet connected Hub - no longer available
...
Ethernet LED The ethernet LED shows the connectivity status between the Hub and the Platform Off: No network → Check if the ethernet cable is plugged in on both ends. Blue port for the Hub. Orange: Connection not established → Check if the correct ports are opened. For Hubs connected to 4G check for sufficient throughput and instalment of 4G antennas Green: Connected
LoRa LED The LoRa LED shows the readiness of receiving messages from the sensors. The hub will not accept messages if it is not connected to the platform Off: Not ready → Check connection to platform Green: Ready
WI-FI LED The hubs are preconfigured not to send out any wifi signals. The light may turn on during initial boot but will turn itself off after configuration is loaded.
Power LED Off → Powered off Flashing Green → Boot mode Flashing Orange/Green → Reset mode Green → Powered on
When a tab hub (not mini) does not come online, you might be requested to manually update the hub firmware on site: check out the following page on (new) Manually Update Ethernet Hub* Firmware TTES (direct via LAN), describing the steps to take.
...
Configuring the Hub will let you set up the Hub as a router, WIFI client, WIFI extender, or WIFI off. It will also let you choose between DHCP and Static IP for ethernet based connections.
Step 1. Check the firmware version
Step 1.1 Go to the trackio grafana platformJoin the hubs initial open Wi-Fi network (Tabs-xxxxxxx) or connect the hub with a LAN cable (plugged into a black port) to your computer
Step 1.2 Open router mamagementthe hubsetup.html
Step 1.3 Locate the hubSelect button "Hub Info"
Step 1.4 Check if the current firmware version is 1.25.02 or later
Step 2. Factory reset the hub with internet unplugged.
Caution! If the hub is connected to the internet it will reconfigure to the standard MCS configuration
Step 3. Join the hubs initial open Wi-Fi network (Tabs-xxxxxxx) or connect the hub with a LAN cable (plugged into a black port) to your computer
Step 4. Open refresh the configuration hubsetup.html page
Step 5. Select button "Hub Setup"
Step 6. Follow the configuration steps of the configuration tool.hubsetup.html
Frequently asked questions – FAQ
...