Content Comparison

...

Link the device ids from the physical installation to the sensors device name (include area name, customer name (eg customer_area_floor number_room number_X))

Manual mode:

1. Click the device manager tab
2. Search the device name in the list or by typing in the search box
3. Select the line of the device name
4. Click the link icon
5. In the Serial Number field, enter the serial number that is labeled on the sensor (with dashes).
6. Click Link and verify the sensor’s Link Status icon in the table

...

1. Click the Add Area button. The Add Area dialog is displayed.
   
2. In the Area Name field, enter an informative name for the area.PRO TIP: In order to make things a lot easier later on, name the area the exact same as you did in MCS; so that you can automize the linking in Studio later on., include device name, customer name (eg customer_floor number_area)

   1. Tip: Make sure device ID + MCS location is referenced everywhere, so that in Studio you can use the simple search function
      

   2. Tip: do not to set the name of a tenant with number at the beginning (eg tenant name "3F")
       
3. In the Update Frequency field, enter the frequency in seconds at which the sensor will send notifications.
4. For optimal performance, in the Type field, select the type of the area you want to add. 
   
5. In the Center X field, enter the X coordinate in meters of the area’s center.
6. In the Center Y field, enter the Y coordinate in meters of the area’s center.
7. In the Area Width field, enter the area’s horizontal dimension in meters.
8. In the Area Length field, enter the area’s vertical dimension in meters.
9. Optionally, click in the Select Devices field, then select the checkboxes of the devices whose detection areas you want to cover the new area. This can be useful, for example, if you have some knowledge about occlusions in the sensors’ views, and you want to choose the optimal sensor/s for covering your new area.
   
10. Click Save. The area is added and displayed both in the Search pane and as a blue rectangle (assuming it’s a valid area) in the floor plan.

...

1. Go to bohemian (https://studio.cobundu.com/app/bohemian)
2. Check the Auto-create organization devices box
3. Add a new line
4. Select the pointgrab source
5. Select the detection area from the device id drop down list
6. Give a meaningful name: include device name, customer name (eg customer_floor number_area)
7. Select pointgrab as the model
8. select the correct organisation
9. click save
10. Change the location id in the tenant's sensor devices

Make sure device ID is references everywhere + location , so that in Studio you can use the simple search function  

Area name: include device name, customer name (eg customer_floor number_area)