Difficulty: expert
Content
| Table of Contents | ||||
|---|---|---|---|---|
|
Learning Objectives
After reading this article, you’ll be able to:
Configure Parking Monitor Dashboard
Request the dashboard
Validate dashboard setup
Required Setup
Below instructions are specific to the Parking monitor dashboard. Make sure to also check the FAQ in Dashboard activation.
Make sure the location category is mapped to the Cobundu Space Category Parking as described in Tenant Setup Studio settings
https://spacewell.atlassian.net/wiki/spaces/KB/pages/491834/Bosch+PLS+installation+guidewas done according to instructions
Request Dashboard setup
Request the Parking Monitor Dashboard with your Spacewell Account Manager.
After the sensors are sending data to the Workplace IoT platform, your Spacewell Implementation consultant will book a Spacewell internal ticket to request the dashboard to be set up.
Quality Assurance
Verify following general points:
Locations correct?
Number of rooms correct?
Is floorplan loading correctly?
Zone description correct?
Typos?
Number of floors
Check Dashboards Space category mapping
Check Studio health view
Check locations master data in IWMS + config of locations in Location Grouping and Room Capacity
If you notice anything strange on the dashboard, consider the following:
Check config of sensors in Studio (Sensor Devices: correct Device ID, linked to Room or Workplace object, linked to Zone etc)
Check config of floorplans in Studio (and IWMS if relevant)
Check locations master data in IWMS + config of locations in Studio Location Grouping and Room Capacity
Check Dashboards Space category mapping in Studio > Settings > Dashboards
Check installation of sensors + on-site environment (might be empty due to Covid or warmer due to climate)
If any values are off the charts, book a call for the BI team to check the incoming values (Incidents > Cobundu Incidents > Nature: Cobundu Dashboards)
Search
| Live Search |
|---|