* No longer available
| Table of Contents |
|---|
...
Ethernet LED The ethernet LED shows the connectivity status between the Hub and the Platform Off: No network → Check if the ethernet cable is plugged in on both ends. Blue port for the Hub. Orange: Connection not established → Check if the correct ports are opened. For Hubs connected to 4G check for sufficient throughput and instalment of 4G antennas Green: Connected
LoRa LED The LoRa LED shows the readiness of receiving messages from the sensors. The hub will not accept messages if it is not connected to the platform Off: Not ready → Check connection to platform Green: Ready
WI-FI LED The hubs are preconfigured not to send out any wifi signals. The light may turn on during initial boot but will turn itself off after configuration is loaded.
Power LED Off → Powered off Flashing Green → Boot mode Flashing Orange/Green → Reset mode Green → Powered on
When a tab hub (not mini) does not come online, you might be requested to manually update the hub firmware on site: check out the following page on (new) Manually Update Ethernet Hub* Firmware TTES (direct via LAN), describing the steps to take.
...