Versions Compared

Version Old Version 1 New Version Current
Changes made by

Gilles Ghyssaert

Julie Isebaert

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Difficulty: expert

Content

Table of Contents
minLevel1
maxLevel1

Learning Objectives

After reading this article, you’ll be able to:

  • Configure the Kiosk App through Device Control to run on a Qbic meeting room display

This manual is applicable for the following meeting room devices

QBIC - TD-1070

Image Added

QBIC - TD-1060

Image Added

QBIC - TD-1050

Image Added

Prerequisites

  1. You’ll need both a Qbic device + a PC

  2. Both devices should be on the same network

  3. Create a device account (i.e. the device account that will be used to log into the Kiosk application) in Users & Groups

  4. Ideally, you’ve already configured a Profile and a Theme, see Customizing the Room Display

Step 1 - 3 - Install & Launch the app

see Device Control for QBIC

Step 4 - Configure the app

Expand
titleOn the device, log in with the device account

You will have to provide the device account that has been configured in Users & Groups

(warning) If your device account is already in use by another Kiosk app, you will receive an error message. You’ll have to go to https://devicecontrol.cobundu.com/ and unlink the account used by the other kiosk.

Image Added

Expand
titleWait for the app to ask for a configuration

If this is the first time you use the device account, the app will launch and give an error. Don’t panic, this is completely normal (wink) The app is asking which locations and profile to load.

You’ll need your laptop for the next few steps.

Image Added

Expand
titleOpen device control to set up the new app

Go to https://devicecontrol.cobundu.com/ and log in with an admin account.

You should see you new device in the list with a label “not configured” on the right.

image-20240131-111139.pngImage Added

Expand
titleSelect the device and press START CONFIGURATION

When you select the device, a panel will appear from the bottom. Click on Start configuration.

image-20240131-111259.pngImage Added

Expand
titleSelect Room Display

Select ROOM DISPLAY in the pop-up window that appears

image-20240131-105443.pngImage Added
Expand
titleSelect Room + a profile & theme to be applied

Select the Room you want to see values for, a Profile and a Theme using the drop down menus.

These settings will be pushed to the Kiosk app after you pressed SAVE.

You can customize this later at any point.

Expand
titleYou might need to go back to the device and tap 'retry'

Once you pressed RETRY the app will continue it’s configuration

image-20240131-110925.pngImage Added

Expand
titleCongratulations, you're ready!

Now you’re good to go

Search

Live Search