Difficulty: novice
Content
| Table of Contents |
|---|
...
Manual
Comfort Dashboard v1: Comfort dashboard 2019.pptx
Comfort Dashboard v2:
Comfort Values visualized in dashboard
...
|
Learning Objectives
After reading this article, you’ll be able to:
Read the Comfort Monitor Dashboard
Comfort monitor dashboard provides insight in the historical data that is gathered by comfort devices that send data (can be on temperature, humidity, CO2, …) to Workplace platform. The question it tries to answer is: “Which insight/trend is communicated through the data?”
Historical data means that the visualized data in the dashboard was gathered until yesterday.
“Summary” page
| Expand |
|---|
 |
“Overview” page
| Expand |
|---|
 |
“Analysis” page
| Expand |
|---|
 |
“Analysis - mapping” page
| Expand |
|---|
 If you compare the dataset to the following data, you can get insights in possible solutions:  |
“Thresholds” page
| Expand |
|---|
 |
“Scope & capacities” page
| Expand |
|---|
 |
“Analysis CO2 vs Utilization” page
| Expand |
|---|
“Analysis CO2 vs Utilization” sheet will only be deployed if both CO2 and utilization are measured for the same locations in this environment.  Every dot on the following representation is a measurement:   |
Comfort Values visualized in dashboard
Logic behind visualization: Average temperature value for room X (if 2 comfort sensors are linked to that room) = (10 °C +20 °C) / 2 = 15 °C and this is how it will be exposed in the timeslots. Check out the scenarios/use cases concerning the visualization of comfort data on Live Floorplan and in Dashboards on Live floorplan settings-page.
Comfort values set in Studio Settings > Plan influence the colors in the gauges in the Comfort Monitor dashboard
Quality Assurance
Please use following slide deck as a guide line of how to do a Quality Check on a brand new published dashboard:
| View file | ||||
|---|---|---|---|---|
|
If you notice anything strange on the dashboard, please consider the following :
- Check Deployment of listeners and jobs:
- Sensor Listener + Sensor Data Aggregation running?
- MCS API Connector enabled and latest version?
- Check config of sensors in Studio (Sensor Devices: correct Device ID, linked to Room or WP, linked to Zone etc)
- Check config of floorplans in Studio (and IWMS if relevant)
- Check locations master data in IWMS + config of locations in Location Grouping and Room Capacity
- Check Dashboards Space category mapping in Studio > Settings > Dashboards
- Check installation of sensors + customer environment (might be empty due to Covid or warmer due to climate)
- If eg comfort values are off the charts, book a call for the BI team to check the incoming values (Incidents > Cobundu Incidents > Nature: Cobundu Dashboards)
...
More information
Frequently Asked Questions on Dashboards
Check out FAQ on Dashboards
How to navigate the Dashboards
Search
| Live Search |
|---|