Prerequisites
...
Difficulty: expert
Content
| Table of Contents | ||||
|---|---|---|---|---|
|
Learning Objectives
After reading this article, you’ll be able to:
Configure the Kiosk App through Device Control to run on a Qbic meeting room display
This manual is applicable for the following meeting room devices
QBIC - TD-1070
QBIC - TD-1060
QBIC - TD-1050
Prerequisites
You’ll need both a Qbic device + a PC
Both devices should be on the same network
...
You should see the screen below on your Qbic device (the Content URL is empty at first)
...
ℹ️ To get your Qbic device ready and connected, consult the Hardware installation (Qbic)
...
| title | Uninstall previously installed apps if any |
|---|
Note: Only relevant if you are still running a Kiosk App that is not linked to Device Control.
-> Skip this step if this is the first time you are installing the app
This step applies to any type of device (Qbic or other brands)
...
...
...
...
Exit the app
...
Find the app on the device
...
Uninstall the app
...
Tap 10x on the logo
Enter the device password
Select ‘Exit’
...
Select ‘Settings'
go to Advanced settings’
Select ' apps'
...
Select the ' kiosk' app
Select ‘uninstall’
Step 1 - Find the Qbic Device on Device Control
...
Create a device account (i.e. the device account that will be used to log into the Kiosk application) in Users & Groups
Ideally, you’ve already configured a Profile and a Theme, see Customizing the Room Display
Step 1 - 3 - Install & Launch the app
Step 4 - Configure the app
| Expand | ||
|---|---|---|
| ||
You will have to provide the device account that has been configured in Users & Groups
 |
| Expand | ||
|---|---|---|
| ||
If this is the first time you use the device account, the app will launch and give an error. Don’t panic, this is completely normal You’ll need your laptop for the next few steps.  |
| Expand | ||
|---|---|---|
| ||
Go to https://devicecontrol.cobundu.com/ and log in with an admin account. You should see you new device in the list with a label “not configured” on the right.  |
| Expand | ||
|---|---|---|
| ||
When you select the device, a panel will appear from the bottom. Click on Start configuration.  |
| Expand | ||
|---|---|---|
| ||
Select ROOM DISPLAY in the pop-up window that appears  |
| Expand | ||
|---|---|---|
| ||
Select the Room you want to see values for, a Profile and a Theme using the drop down menus. These settings will be pushed to the Kiosk app after you pressed SAVE. You can customize this later at any point. |
| Expand | ||
|---|---|---|
| ||
Once you pressed RETRY the app will continue it’s configuration  |
| Expand | ||
|---|---|---|
| ||
Now you’re good to go |
Search
| Live Search |
|---|