Difficulty: expert

This manual is applicable for the following meeting room devices

Prerequisites

1. You’ll need both a Qbic device + a PC

2. Both devices should be on the same network

You should see the screen below on your Qbic device (the Content URL is empty at first)

Image Removed

ℹ️ To get your Qbic device ready and connected, consult the Hardware installation (Qbic)

Expand

title	Uninstall any previously installed Kiosk app if any (skip this step for first time installation)

Note: Only relevant if you are still running a Kiosk App that is not linked to Device Control.
ℹ️ This step applies to any type of device (Qbic or other brands)

Image Removed

Image Removed

Image Removed

Exit the app

Find the app on the device

Uninstall the app

1. Tap 10x on the logo

2. Enter the device password

3. Select ‘Exit’

1. For Qbic, select ‘Settings'

2. go to ' Advanced settings’

3. Select ' apps'

1. Select the ' kiosk' app

2. Select ‘uninstall’

Step 1 - Find the Qbic device through your PC

First, Go to Device Control on your PC:

2. Create a device account (i.e. the device account that will be used to log into the Kiosk application) in Users & Groups

3. Ideally, you’ve already configured a Profile and a Theme, see Customizing the Room Display

Step 1 - 3 - Install & Launch the app

see Device Control for QBIC

Step 4 - Configure the app

Expand
title On the device, log in with the device account
You will have to provide the device account that has been configured in Users & Groups If your device account is already in use by another Kiosk app, you will receive an error message. You’ll have to go to https://devicecontrol.cobundu.com/ and unlink the account used by the other kiosk. Image Added

Expand
title Wait for the app to ask for a configuration
If this is the first time you use the device account, the app will launch and give an error. Don’t panic, this is completely normal The app is asking which locations and profile to load. You’ll need your laptop for the next few steps. Image Added

Expand
title Open device control to set up the new app
Go to https://devicecontrol.cobundu.com/ and log in with an admin account. You should see you new device in the list with a label “not configured” on the right. Image Added

Expand
title Select the device and press START CONFIGURATION
When you select the device, a panel will appear from the bottom. Click on Start configuration. Image Added

Expand
title Select Room Display
Select ROOM DISPLAY in the pop-up window that appears Image Added

Expand
title You might need to go back to the device and tap 'retry'
Once you pressed RETRY the app will continue it’s configuration Image Added

Search