Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 6 Next »

 


This guide focuses on the configuration of the Pointgrab devices on the Pointgrab cognipoint management system (cpms) and Studio.
This guide assumes a configured asset tree in cpms with floorplan.

For a more detailed understanding of the CPMS please consult the manual.

Deploying sensors CPMS

Link the device ids from the physical installation to the sensors device name

Manual mode:

  1. Click the device manager tab
  2. Search the device name in the list or by typing in the search box
  3. Select the line of the device name
  4. Click the link icon
  5. In the Serial Number field, enter the serial number that is labeled on the sensor (with dashes).
  6. Click Link and verify the sensor’s Link Status icon in the table

CSV mode:

  1. Fill in the following csv file, and keep the format (number of enters between blocks, indenting, etc.)

  2. Select the correct floor in the asset tree
  3. Click the import button
  4. Browse for the file and click ok.

Defining areas CPMS

Define the areas where the sensors will measure headcounts (eg. different workplaces to be covered by 1 Pointgrab sensor)

→ of course, all of these areas need to be within the Detection Area (check Pointgrab installation guide for info on Detection Area linked to Installation Height)

! Mind that even if the Detection Area might be large enough to cover more than 10 work places, CPMS has a limit to max 10 areas per device, so if you create more in CPMS, the device will appear offline.

 

  1. Click the Add Area button. The Add Area dialog is displayed.
  2. In the Area Name field, enter an informative name for the area.
    1. PRO TIP: In order to make things a lot easier later on, name the area the exact same as you did in MCS; so that you can automize the linking in Studio later on. 
  3. In the Update Frequency field, enter the frequency in seconds at which the sensor will send notifications.
  4. For optimal performance, in the Type field, select the type of the area you want to add. 
  5. In the Center X field, enter the X coordinate in meters of the area’s center.
  6. In the Center Y field, enter the Y coordinate in meters of the area’s center.
  7. In the Area Width field, enter the area’s horizontal dimension in meters.
  8. In the Area Length field, enter the area’s vertical dimension in meters.
  9. Optionally, click in the Select Devices field, then select the checkboxes of the devices whose detection areas you want to cover the new area. This can be useful, for example, if you have some knowledge about occlusions in the sensors’ views, and you want to choose the optimal sensor/s for covering your new area.
  10. Click Save. The area is added and displayed both in the Search pane and as a blue rectangle (assuming it’s a valid area) in the floor plan.

Finetuning CPMS

Finetune the location of the area and the sensor device by comparing the live view and the on site situation

Deploying sensors Studio

  1. Go to bohemian (https://studio.cobundu.com/app/bohemian)
  2. Check the Auto-create organization devices box
  3. Add a new line
  4. Select the pointgrab source
  5. Select the detection area from the device id drop down list
  6. Give a meaningful name
  7. Select pointgrab as the model
  8. select the correct organisation
  9. click save
  10. Change the location id in the tenant's sensor devices

 

 

 


  • No labels