Required configuration in IWMS and Cobundu Studio for optimal use of the dashboards: Dashboards IWMS & Studio Setup.pptx
A general introduction to the Dashboards has been presented during the Cobundu Summer 2021 Sessions, this is the recording: Summer 2021 Session: Dashboards
Frequently Asked Questions on Dashboards
Remember that we're using Qlik, a 3rd party application, and are unfortunately also bound to their limitations.
Valid for ALL sensors: for the sensors to eventually turn up in the dashboards, the sensors need to be triggered. It's up to the IC to judge, depending on the customer situation (activity going on or not), if all sensors need to be triggered upon installation, or if it will be done by end users.
- Remember that if none of the sensors linked to a specific department/zone are triggered, the department/zone will not show up in the dashboard. On the other hand: not triggered sensors generally means that zone is not used.
Time Zones
Time Zone settings for sensors are required for all tenants; the system will however try to determine it depending system settings either from IWMS or from Cobundu by means of a waterfall system, if one is detected it exit’s and uses that setting (ignoring the rest).
Using the wrong setting will result in offset in the week overview. Changing the time zone will not recursively correct earlier sensor recordings, this needs then to be manually triggered by the Cobundu team.
