Difficulty: expert
Content
Learning Objectives
After reading this article, you’ll be able to:
Configure Space Monitor Dashboard
Request the dashboard
Validate dashboard setup
Required Setup
There are no Comfort Monitor dashboard specific instructions, a part from making sure sensor installation was done according to instructions.
Make sure to check the FAQ in Dashboard activation.
[Spacewell Internal : In case you have any questions on where information in the dashboard is coming from or how it is set up, you can check DASHBOARD CONFIGURATIONS GUIDELINES ]
Request Dashboard setup
Request the Comfort Monitor Dashboard with your Spacewell Account Manager.
After the sensors are sending data to the Workplace IoT platform, your Spacewell Implementation consultant will book a Spacewell internal ticket to request the dashboard to be set up.
Quality Assurance
Keywords relevant to dashboards
Filter
KPI
Full screen vs Exploration Menu (to change graph values)
Expected patterns: eg values lower at night/weekends
Anomaly: eg values being 100%; values showing 0% during week days
Summary Page
Comfort OVERVIEW page
Comfort ANALYIS page
Analysis MAPPING
Thresholds
Scope & Capacities
Analysis CO2 vs utilization
If you notice anything strange on the dashboard, consider the following:
Check config of sensors in Studio (Sensor Devices: correct Device ID, linked to Room or Workplace object, linked to Zone etc)
Check config of floorplans in Studio (and IWMS if relevant)
Check locations master data in IWMS + config of locations in Studio Location Grouping and Room Capacity
Check Dashboards Space category mapping in Studio > Settings > Dashboards
Check installation of sensors + on-site environment (might be empty due to Covid or warmer due to climate)
If any values are off the charts, book a call for the BI team to check the incoming values (Incidents > Cobundu Incidents > Nature: Cobundu Dashboards)
Search