Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 3 Next »

Difficulty: expert

Content

Learning Objectives

After reading this article, you’ll be able to:

  • Configure Parking Monitor Dashboard

  • Request the dashboard

  • Validate dashboard setup

Required Setup

Below instructions are specific to the Parking monitor dashboard. Make sure to also check the FAQ in Dashboard activation.

  1. ‪Make sure the location category is mapped to the Cobundu Space Category Parking as described in Tenant Setup

  2. https://spacewell.atlassian.net/wiki/spaces/KB/pages/491834/Bosch+PLS+installation+guidewas done according to instructions

Request Dashboard setup

Request the Parking Monitor Dashboard with your Spacewell Account Manager.
After the sensors are sending data to the Workplace IoT platform, your Spacewell Implementation consultant will book a Spacewell internal ticket to request the dashboard to be set up.

Quality Assurance

If you notice anything strange on the dashboard, consider the following:

  • Check config of sensors in Studio (Sensor Devices: correct Device ID, linked to Room or Workplace object, linked to Zone etc)

  • Check config of floorplans in Studio (and IWMS if relevant)

  • Check locations master data in IWMS + config of locations in Studio Location Grouping and Room Capacity

  • Check Dashboards Space category mapping in Studio > Settings > Dashboards

  • Check installation of sensors + on-site environment (might be empty due to Covid or warmer due to climate)

  • If any values are off the charts, book a call for the BI team to check the incoming values (Incidents > Cobundu Incidents > Nature: Cobundu Dashboards)

Search

  • No labels