Difficulty: expert
Content
| Table of Contents | ||||
|---|---|---|---|---|
|
Learning Objectives
After reading this article, you’ll be able to:
Set up your IT network as needed for Vergesense installation
| Note |
|---|
This Page is still in Draft / Work in Progress State. |
Hardware Requirements
Vergesense gateways
Vergesense gateways can be cellular (connecting to the Vergesense platform over a 4G sim card), or can connect to your network.
Cellular / 4G gateway needs: DC power (standard 120-volt power outlet) or PoE (Power over Ethernet)
Ethernet / WiFi gateway (connecting to the network) needs:
ethernet option: PoE (Power over Ethernet)
WiFi option: DC power (standard 120-volt power outlet) or PoE (Power over Ethernet)
Vergesense gateways should be installed above human height, so foresee the required cabling either on the ceiling or high up a wall. A VergeSense installation location suggestion will be provided before installation.
Vergesense Sensor
Vergesense Sensors are wireless, so they are super easy to install. Installation is either magnetic or with screws.
Based on the sensor plan (see VergeSense installation location), you will already be able to identify where sensors might be installed with the magnets, and where they will need to be screwed (eg because no T-Bar or other magnetic elements are available in the ceiling in that location).
Network Requirements
When you’re installing the cellular gateway, there is no need to open any ports on your network.
When you’re installing a gateway that connects to your network, you’ll need to open ports XXXXX (coming soon) in the firewall. These ports only need an outbound connection.
| Expand | |||||||
|---|---|---|---|---|---|---|---|
| |||||||
We sync all our hubs to the same open NTP (network time protocol) servers so we have consistent timings in our data warehouse. How to use below table
Depending on the environment main location, Spacewell Workplace tenants are created in an EU- or US-environment. Hence, for some ports to be opened, the destination address might be a different one:
|
When installing a WiFi gateway, communicate the SSID and login data (login and password) of the WiFi network. VergeSense will preconfigure the device by hard coding the details to device PRIOR to shipment.
| Warning |
|---|
After communication of SSID & login data to VergeSense, there should be no more changes to the WiFi network, else the gateway will not be able to connect. |
Next steps
If sensor plans are provided (see VergeSense installation location), VergeSense gateway installation can happen.
Search
| Live Search |
|---|