Difficulty: expert
Content
| Table of Contents | ||||
|---|---|---|---|---|
|
Learning Objectives
After reading this article, you’ll be able to:
prepare on-site locations for Zens installation
Installation is done by Zens.Requirements:
Prerequisites
For the PuK IoT Visual / wireless charger:
A hole with a diameter of 81 mm needs to be drilled in the table at the position where the PuK IoT Visual should be placed.
230V power plug
The motion sensor needs to be installed in the center at the bottom of the desk.
The ideal distance from the front of the desk to the front of the sensor is 300 to 350 mm
Provide an unobstructed view of the sensor for an optimal detection area
The motion sensor will be screwed with two screws on the underside of the desk
Search
| Live Search |
|---|