...
A huge chunk of the general introduction on Sensor Installation that has been presented during the Cobundu Summer 2021 Sessions was about Motion Tabs Installation, this is the recording: Summer 2021 Session: Sensor Installation
Installation Flow
General
1. Decide HOW to install
• Check if locations apply to prerequisites described in this document. If there are any deviations to these prerequisites, please contact your Implementation Consultant at Spacewell with a description and, ideally, pictures of the situation
...
French version : Motion Tab Guide d Installation.pptx (v2020)
Workplace
Always check the detailed instruction in the Motion Tab Placement Guide.
...
Sensor unpack & placement indication
Take sticker from packaging and stick it to the sensor plan
Remove sensor from packaging
Tape placement
Cap placement (different for "normal" vs "height adjustable" tables!): to install the cap on the sensor, just pull the strip, exposing the adhesive.
Sensor placement
underneath normal table (between 60-80 cm high (not height adjustable to standing table)): vertical/ downwards + perpendicular to table (short side sensor parallel to long side table)
underneath height adjustable table: longest face of the sensor is parallel to the front of the desk and the lens facing downwards (long side sensor parallel to long side table)
Meeting room
Always check the detailed instruction in the Motion Tab Placement Guide.
...
Sensor unpack & placement indication
Take sticker from packaging and stick it to the sensor plan
Remove sensor from packaging
Tape placement
Sensor placement on ceiling, in the middle of the room: perpendicular to room (long side sensor parallel to short side room)
Rooms under 4x4m (bubbles, phone booths, concentration rooms, ...)
Always check the detailed instruction in the Motion Tab Placement Guide.
...
Sensor unpack & placement indication
Take sticker from packaging and stick it to the sensor plan
Remove sensor from packaging
Tape placement
Sensor placement on wall of the door, at the entrance of the room
Mind that if the door opens to the inside, there might be a reflection on that door. It might be advisable to then place the sensor behind the door (assuming people close the door to start using this space – and thereby trigger the sensor).
Examples
Tape Placement
...
Cap Placement
...
Workplace (normal) |   |
Workplace (height adjustable table) |   |
Sensor Placement
Workplace (normal, not height adj.) placement
...
Meeting room placement
...
Rooms under 4x4m placement
...