Difficulty: novice
Content
| Table of Contents | ||||
|---|---|---|---|---|
|
Learning Objectives
After reading this article, you’ll be able to:
Verify what is needed for motion sensor installation
Define installation method depending on the use case
Watch out for mistakes that were made at other installations
Prerequisites
| Note |
|---|
Motion sensors connect over the LoRa network. Make sure you install your LoRa hub before installing the sensors (check out LoRa Gateways / Hubs installation guides for more information). |
Prepare you sensor plan (floorplan with dimensions and markings of where the sensors need to come) has been set up.
Verify you have everything to go on site: Checklist for hardware on-site visit/installation
Make sure to communicate to the workplace users on site what is happening (change management).
Decide installation method depending on use case
Depending on the location/use case, the installation method will be different:
Workplace (normal, not height adj.) placement, see Motion sensor installation at Workplaces
Sensor installation Tips & Tricks
Don’t place tape on the side with the QR code
Place the eye towards the seating area of the workplace or facing down the ground
Aim the eye facing down away from strong heating or cooling sources (fireplace, HVAC)
What happened before - don’t let it happen again…
Eye of workplace sensor very close against a metal stud
Meeting room sensor towards the door
Sensor on a movable table
Sensor below a chair instead of table
Sensor on top of the table
Sensors/touch point installation in a “construction” site
Search
| Live Search |
|---|