Difficulty: expert

Required Setup

There are no Comfort Monitor dashboard specific instructions, a part from making sure sensor installation was done according to instructions.

“Analysis CO2 vs Utilization” sheet can only be deployed if both CO2 and utilization are measured for the same locations in this environment.

Make sure to check the FAQ in Dashboard activation Dashboards.

[Spacewell Internal : In case you have any questions on where information in the dashboard is coming from or how it is set up, you can check DASHBOARD CONFIGURATIONS GUIDELINES ]

Request Dashboard setup

Request the Comfort Monitor Dashboard with your Spacewell Account Manager.
After the sensors are sending data to the Workplace IoT platform, your Spacewell Implementation consultant will book a Spacewell internal ticket to request the dashboard to be set up.

Quality Assurance

Verify following general points:

• Locations correct?

• Number of rooms correct?

• Is floorplan loading correctly?

• Zone description correct?

• Typos?

• Number of floors

• Check Dashboards Space category mapping

• Check Studio health view

• Check locations master data in IWMS + config of locations in Location Grouping and Room Capacity

Keywords relevant to dashboards

‪Expected patterns: eg values lower at night/weekends

‪Anomaly: eg values being 100%; values showing 0% during week days

Summary Page

Expand
Image RemovedImage Added

Comfort OVERVIEW page

Expand
Image RemovedImage Added

Comfort ANALYIS page

Expand
Image RemovedImage Added

Analysis MAPPING

Expand
Image Added

Thresholds

Expand
Image Added

Scope & Capacities

Image Removed

Expand
Image Added

Analysis CO2 vs utilization

Expand
“Analysis CO2 vs Utilization” sheet will only be deployed if both CO2 and utilization are measured for the same locations in this environment. Quality Assurance for this sheet is done by quality check on Space Monitor quality check on CO2 data on the other sheets of the Comfort Monitor Image Added

If you notice anything strange on the dashboard, consider the following:

• Check config of sensors in Studio (Sensor Devices: correct Device ID, linked to Room or Workplace object, linked to Zone etc)

• Check config of floorplans in Studio (and IWMS if relevant)

• Check locations master data in IWMS + config of locations in Studio Location Grouping and Room Capacity

• Check Dashboards Space category mapping in Studio > Settings > Dashboards

• Check installation of sensors + on-site environment (might be empty due to Covid or warmer due to climate)

• If any values are off the charts, book a call for the BI team to check the incoming values (Incidents > Cobundu Incidents > Nature: Cobundu Dashboards)

Search