Difficulty: expert
Content
Learning Objectives
After reading this article, you’ll be able to:
configure Zens sensors in Workplace
send Zens data to Workplace
Data-Stream Configuration
Zens will connect to the Workplace platform through Generic Endpoint.
Deploy sensors in Workplace Platform
Add New Device in Workplace back-end Studio
Go to your environment (https://studio.cobundu.com ) and log in
Select the location, where you can manually add a sensor via "Add New Device"
Manually add device through location > devices > new: location is filled in.
Select Device Type "Generic PIR". This will automatically link the device channel.
Enter Device ID as
prefix “zens|”
device ID will be provided by the ZENS project team
example: “zens|867723035258986”
Enter a meaningful Device Name (eg customer_floor number_area).
Select a Location from the location tree if this is already known (automatically filled in if location was selected before adding new device).
Linked Locations is not relevant for this kind of sensor.
Selecting the correct Device Type "Generic PIR" should automatically set the Type to "Presence" and the Channel to “PIR” (see Advanced).
For more information on how to add multiple new devices to Studio, check out Configure devices (add, remove, import/export).
Quality Assurance
Next step is the Quality Assurance to make sure that the whole installation and configuration of your Motion sensor was a success. See Quality Assurance Occupancy/Utilization Sensor
Check the Motion Sensor
The sensor LED will glow green when the motion sensor is properly connected. This is the sign that the sensor is receiving power.
Note: If the green LED does not work, check the RJ12 connections to the charging module.
After connection, the LED sensor will flash orange. After 30 seconds the flashing will stop and the sensor is in use
Wave your hand slowly 5 to 10 times in front of the sensor. This will activate the motion sensor, and the sensor's LED will turn orange Checking the motion sensor and power supply Note: If this does not happen, the entire RJ12 cabling and power supply must be checked.
After the installation of the charging module and the motion sensor, the working can be checked.
If the motion sensor works properly and has detected movement, the LED ring will turn red. If this does not happen, the entire RJ12 cabling and power supply must be checked.
Search