Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

Version 1 Next »

Difficulty: expert

Content

Learning Objectives

After reading this article, you’ll be able to:

  • Configure the Kiosk App through Device Control to run on a Qbic meeting room display

This manual is applicable for the following meeting room devices

QBIC - TD-1070

QBIC - TD-1060

QBIC - TD-1050

Prerequisites

  1. You’ll need both a Qbic device + a PC

  2. Both devices should be on the same network

  3. Create a device account (i.e. the device account that will be used to log into the Kiosk application) in Users & Groups

  4. Ideally, you’ve already configured a Profile and a Theme, see Customizing the Room Display

Step 1 - 3 - Install & Launch the app

see Device Control for QBIC

Step 4 - Configure the app

 On the device, log in with the device account

You will have to provide the device account that has been configured in Users & Groups

(warning) If your device account is already in use by another Kiosk app, you will receive an error message. You’ll have to go to https://devicecontrol.cobundu.com/ and unlink the account used by the other kiosk.

 Wait for the app to ask for a configuration

If this is the first time you use the device account, the app will launch and give an error. Don’t panic, this is completely normal (wink) The app is asking which locations and profile to load.

You’ll need your laptop for the next few steps.

 Open device control to set up the new app

Go to https://devicecontrol.cobundu.com/ and log in with an admin account.

You should see you new device in the list with a label “not configured” on the right.

image-20240131-111139.png

 Select the device and press START CONFIGURATION

When you select the device, a panel will appear from the bottom. Click on Start configuration.

image-20240131-111259.png

 Select Room Display

Select ROOM DISPLAY in the pop-up window that appears

image-20240131-105443.png
 Select Room + a profile & theme to be applied

Select the Room you want to see values for, a Profile and a Theme using the drop down menus.

These settings will be pushed to the Kiosk app after you pressed SAVE.

You can customize this later at any point.

 You might need to go back to the device and tap 'retry'

Once you pressed RETRY the app will continue it’s configuration

image-20240131-110925.png

 Congratulations, you're ready!

Now you’re good to go

Search

  • No labels