Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 6 Next »

Difficulty: expert

Content

Learning Objectives

After reading this article, you’ll be able to:

  • Install PointGrab devices, using PoE or WiFi

Make sure to check Xovis hardware & network requirements prior to sensor installation.

Create a sensor plan before going on site, so that all parties are aligned on Xovis installation location.

Unboxing

Contents of the XOVIS package:

  • device (lenses covered with protectors)

  • white cover

  • information booklet

Mounting instructions

After defining the sensor layout, you'll need to install the physical XOVIS sensor devices on the ceiling or against the wall. The sensor layout determines the exact installation location of the sensors, and you must make sure that you install the sensor devices according to the defined specifications.

How to keep track of installation location per device? Best practice is to tape the sticker on the Sensor Plan or take note of the sensor ID (= MAC address = number starting with 4000…) in an excel at the place of installation.

Mounting plate or wall/ceiling mount?

A separate mounting plate and a wall/ceiling mount are available as an accessory.

Installation is possible without an additional plate, depending on the ceiling type. In that case, you can skip step 1.

  1. Fix the mounting plate or wall/ceiling mount onto the ceiling using four M4 screws of your choice. Please define the appropriate screw type depending on the ceiling consistency.

The fixture must be able to carry the fourfold weight of the device, which would correspond to 20N for the sensor.

  1. Pull the Ethernet cable through the hole in the back of the mounting destination and plug in the sensor.

The LED indicates the following states during installation:

  • Green: The device is powered by PoE.

  • Orange or Green blinking: The device is up and running

If you use the white housing, the LED is covered when you successfully mount the housing on the sensor.

  1. Fit the sensor onto the mounting plate and use the two M4x25 Hex lobular socket flanged button head socket screws to fix the sensor.

  1. Remove the dust caps from the sensor lenses (blue/black). Click the cover on the sensor.

  1. After removing the dust cap you can put the white/black cover on the sensor. This clicks into place over 2 little hooks on the side of the sensor.

Quality Assurance

Without the sensor being configured in the XOVIS and Workplace Platform, there is not much you can check.

Next steps

After the sensor installation, follow the Xovis configuration guide, and then follow the Quality Assurance Occupancy/Utilization Sensorinstructions to verify the set-up.

In case you encounter any issue with your devices, don’t hesitate to check Xovis troubleshooting.

Search

  • No labels