Motion sensors connect over the LoRa network. Make sure you install your LoRa hub before installing the sensors (check out LoRa Gateways / Hubs installation guides for more information).

1. Since the dimension of the room should be smaller than 4x4m

2. Ceiling height should be between 2,15m and 4m

Image RemovedImage Added

If the situation you are facing deviates from these instructions/prerequisites, please contact Spacewell. Pictures / Drawings say more than a 1000 words.

1. Go to the room

1. Check the room against the prerequisites. If the prerequisite “Length < 4m AND Width < 4m” is exceeded, please check installation instructions for Meeting Rooms

2. Check the height of the meeting room: Ceiling height between 2,15m and 4m

1. Sensor unpack & placement indication

2. Take sticker from packaging and stick it to the sensor plan

1. Remove sensor from packaging

2. Tape placement

Remove the plastic strip to enable the sensor battery

Sensor placement on ceiling, in the middle of the room: perpendicular to room (long side sensor parallel to short side room)

Top view	Side view

‪If prerequisites are not met, contact your Spacewell Implementation Consultant to check if it is possible to install the sensor, perhaps with a different placement.

‪If sensors are not placed according to Spacewell guidelines, the accuracy cannot be guaranteed.

‪

‪Overview exceptional situations

‪1. Phone booth where walls are entirely made from glass

2. Concentration rooms with only fabric. If table is available: it’s possible to hang underneath the table, but be aware of false positives when door is open.

3. ‪Concentration rooms with difficult design: hang sensor on the wall of the door, looking into the room