Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 4 Next »

Difficulty: expert

Content

Learning Objectives

After reading this article, you’ll be able to:

  • Set up your IT network as needed for Vergesense installation

Hardware Requirements

Vergesense gateways

Vergesense gateways can be cellular (connecting to the Vergesense platform over a 4G sim card), or can connect to your network.

  • Cellular / 4G gateway needs: DC power or PoE (Power over Ethernet)

  • Ethernet / WiFi gateway (connecting to the network) needs:

    • ethernet option: PoE (Power over Ethernet)

    • WiFi option: DC power or PoE (Power over Ethernet)

Vergesense gateways should be installed above human height, so foresee the required cabling either on the ceiling or high up a wall. A VergeSense installation location suggestion will be provided before installation.

Vergesense Sensor

Vergesense Sensors are wireless, so they are super easy to install. Installation is either magnetic or with screws.

Based on the sensor plan (see VergeSense installation location), you will already be able to identify where sensors might be installed with the magnets, and where they will need to be screwed (eg because no T-Bar or other magnetic elements are available in the ceiling in that location).

Network Requirements

When you’re installing the cellular gateway, there is no need to open any ports on your network.

When you’re installing a gateway that connects to your network, you’ll need to open ports XXXXX (coming soon) in the firewall. These ports only need an outbound connection.

 IP Addresses needed for Outgoing traffic

We sync all our hubs to the same open NTP (network time protocol) servers so we have consistent timings in our data warehouse.

How to use below table

  • as mentioned above, ideally just the ports mentioned should be opened (outbound)

We recommend not to use specific IP addresses or DNS destinations in the firewall as they can and probably will change in the future!

  • protocol information and AL descriptions are extra

Depending on the environment main location, Spacewell Workplace tenants are created in an EU- or US-environment. Hence, for some ports to be opened, the destination address might be a different one:

  • eu: spacewell.eu1.cloud.thethings.industries

  • usa: spacewell.nam1.cloud.thethings.industries

Destination

Port

Protocol

Direction

AL description

If you’re installing a WiFi gateway, you’ll need to communicate to VergeSense the SSID and login data of the WiFi network. They will preconfigure the device.

After communication of SSID & login data to VergeSense, there should be no more changes to the WiFi network, else the gateway will not be able to connect.

Next steps

If sensor plans are provided (see VergeSense installation location), VergeSense gateway installation can happen.

Search

  • No labels