Difficulty: expert

Content

Learning Objectives

After reading this article, you’ll be able to:

The data stream setup needs to be done once, then it will be possible to add new builds/areas in scope.

Go to your environment (https://studio.cobundu.com) and log in
Select the location, where you can manually add a sensor via "Add New Device"

Manually add device through location > devices > new: location is filled in.

‪Select Device Type "Signify Occupancy". This will automatically link the device channel.

In Device ID, select the relevant area for this location.

Enter a meaningful Device Name (eg customer_floor number_area).

Select a Location from the location tree if this is already known (automatically filled in if location was selected before adding new device).

Linked Locations is not relevant for this kind of sensor.

Selecting the correct Device Type "Signify Occupancy" should automatically set the Type to "Presence" and the Channel to “PIR” (see Advanced).

For more information on how to add multiple new devices to Studio, check out Configure devices (add, remove, import, and export).

Next step is the Quality Assurance to make sure that the whole installation and configuration of your Motion sensor was a success. See Quality Assurance Occupancy and Utilization Sensor

Search