Hardware installation (Qbic)
- Gilles Ghyssaert
- Julie Isebaert
Difficulty: expert
Learning Objectives
After reading this article, you’ll be able to:
Install Qbic meeting room display devices
Perform initial configurations on Qbic devices
Prerequisites for all models
All devices can be mounted either using a TAPE or with SCREWS - both included in the box
In case a new tape needs to be procured, this is the one that comes with the devices (3M VHB:
Quick start guide per model
For the complete installation instructions (eg Surface preparation for applying adhesive tape) and removal instructions:
Preparing the device to install the app
Step 1: Power the device
The device will launch automatically after connecting it to a power supply.
The device does not have a fixed battery; therefore, it is important to maintain a stable power supply.
Step 2: Connect to the network
Connecting to a wired network happens automatically when plugging in the (POE) Ethernet cable.
Make sure Ethernet is enabled in your POE switch.
Specific configuration such as subnet mask, fixed IP etc. can also be configured via the device's home screen.
The wireless network can be configured via the app's home screen:
In case your device seems to be stuck in the booting process, you will need to reset the device: there is a hole labelled "reset" at the back. Power on the device and push a paperclip for 10 seconds in the reset hole (you should feel a click when pushing the reset button).
Step 3: Check firmware version
Make sure the latest version required firmware version is installed.
At least version v1.0.18 must be installed.
The version can be checked on the home screen (see screenshot below):
Upgrades of the firmware can be managed via remote Device Control for Kiosk App
Step 4: Install the app using Spacewell Device Control
You have now successfully installed the Qbic Meeting Room Display.
In order to further configure the device and install the Room Display app, follow the instructions for Installing the Room Display app
Search