Installing the Room Display app
Difficulty: expert
Learning Objectives
After reading this article, you’ll be able to:
Configure the Kiosk App through Device Control to run on a Qbic meeting room display
This manual is applicable for the following meeting room devices
QBIC - TD-1070
QBIC - TD-1060
QBIC - TD-1050
Prerequisites
You’ll need both a Qbic device + a PC
Both devices should be on the same network
Create a device account (i.e. the device account that will be used to log into the Kiosk application) in Users and Groups
Ideally, you’ve already configured a Profile and a Theme, see Customizing the Room Display
Step 1 - 3 - Install & Launch the app
Step 4 - Configure the app
You will have to provide the device account that has been configured in Users and Groups
If your device account is already in use by another Kiosk app, you will receive an error message. You’ll have to go to https://devicecontrol.cobundu.com/ and unlink the account used by the other kiosk.
If this is the first time you use the device account, the app will launch and give an error. Don’t panic, this is completely normal The app is asking which locations and profile to load.
You’ll need your laptop for the next few steps.
Go to https://devicecontrol.cobundu.com/ and log in with an admin account.
You should see you new device in the list with a label “not configured” on the right.
When you select the device, a panel will appear from the bottom. Click on Start configuration.
Select ROOM DISPLAY in the pop-up window that appears
Once you pressed RETRY the app will continue it’s configuration
Search