Motion sensor holder
- Julie Isebaert
Difficulty: novice
Content
Learning Objectives
After reading this article, you’ll be able to:
install motion sensor using the holder
A sensor holder was developed to answer a couple of questions related to motion sensor installation:
how to ensure that the sensors do not easily get knocked off or fall down?
how to allow easy maintenance of the sensors (for example battery replacement)
how to allow easy sensor removal or replacement?
The holders are designed to be mounted in 4 ways: on the wall, straight and 45 degrees both ways. This makes it possible to mount them on flat surfaces.
The sensor then clips in smoothly but firmly.
Prerequisites
Required:
1 holder per sensor
screwdriver
tape or 1 screw per holder/sensor: Use a small screw and make sure that the head fits, so it is not higher than the plastic
Make sure that the screw is the right length, so it doesn’t go through the tabletop. The tabletop may vary in thickness.
For more information to prepare hardware related on-site visits, see Checklist hardware on-site visit or installation
Mounting instructions
Make sure to follow Motion sensor installation instructions on how to prepare the desk or room, and measure where exactly to install the sensor.
Workplaces
Check Motion sensor installation at Workplaces for detailed, different instructions for normal desks and for height adjustable desks.
Meeting Rooms under 4x4m
See Motion sensor installation in Rooms under 4x4m for detailed instructions on sensor positioning.
Meeting Rooms
According to the Motion sensor installation in Meeting Rooms guide, install the sensor on the ceiling, in the middle of the meeting room.
Search